![]() ![]() If the line still appears, please contact us for further steps and assistance. ![]() ![]() You can then lift the credit card when reaching the end of the glass and return to the other side to slide it across again.Īfter cleaning the platen glass, run four to five blank/clean pages through to test it. NOTE: Please do not spray the cleaning solution on the glass.Īnother way to ensure the mark is removed is to use a credit card by placing in on a angle and sliding it across the glass in one direction. You can use a soft lint free cloth either dry, with a little soap and water or water to clean the glass and may have to scrub until it squeaks to remove certain types of marks. Look for scratches, tiny spots and marks of any sort. There can also be a strip of transparent plastic on which there can be a mark or smudge. You will want to carefully and fully clean the glass in the ADF scanning area. The scanning light sits in this area when using the ADF. A margin of 1/4' (5 mm) or less around the edge of paper or 3/8' (10 mm) or less around the edge of envelopes is not printable with the machine. The ADF roller is located on the left and underside of your lid. This symptom occurs if a margin is set to none in the printer driver. A small smudge on the platen glass can cause a "line" to be produced as every inch of the paper fed via the ADF passes over the area and is picked up by the scanner. If the line that is being produced only occurs when using the Automatic Document feeder (ADF) and not when making a copy via the platen glass, the issue is commonly due to a small mark or debris on the scanning glass area that lines up underneath the white vertical ADF roller.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |